Get six months of ceramic protection in minutes! The spray-on, rinse-off application creates a long-lasting bond after water hits treated surfaces. Once activated, the product leaves a deep glossy finish that feels slick to the touch. 303® Spray & Rinse Ceramic Sealant is also great to use on wheels thanks to the easy activation method that eliminates the need to fit into tight spaces to achieve desired results.
Directions (If Applicable):
Wash your car out of direct sunlight when the vehicle’s surface is cooled. While the exterior is still wet, spray a small amount of product evenly, treating one section of the car at a time. After spraying a light mist, immediately rinse the section off with water. You will see water beading on the surface, indicating that it is now protected. Repeat steps on all areas of the vehicle, and then dry thoroughly with a waffle weave drying towel or microfiber towel.
This product can be applied to all vehicle exterior surfaces. It is safe and effective on paint, clear coat, wheels, glass, plastics, fiberglass, gel-coat, aluminum, hard plexiglass, and more!
Water spots and streaks can occur if the product is used on a hot surface, so make sure your vehicle is cool, wet, and out of direct sunlight when applying this product. If you experience spots or streaks due to using it on a hot surface, you will need to rinse the surface again, and then also use a microfiber towel to buff these off.
Spots and streaks can also occur if too much product is sprayed on, and not rinsed off thoroughly or quickly after applying. If spots occur due to this reason, they can easily be removed simply by rinsing surface off again.
Also, make sure you dry your vehicle like you normally would (drying towel, etc.) after applying product and rinsing off. Letting the vehicle air dry can also cause water spots to form.
Yes, this product is safe for use on matte paint.
